Product Manual

Cod. 9828093011 00 - Edition 03/2015 - 49
ENGLISH



23 REPLACING OIL FILTER AND OIL SEPARATOR FILTER

BEFORE PERFORMING ANY MAINTENANCE THE MACHINE MUST BE STOPPED, CUT OFF THE MACHINE FROM THE
ELECTRICAL MAINS AND FROM THE COMPRESSED AIR DISTRIBUTION CIRCUIT, CHECK THAT THE MACHINE IS NOT
UNDER PRESSURE.


REPLACING Oil SEPARATOR FILTER
Before proceeding with the replacement of the de-oiler filter or the oil filter check that there is no pressure in the machine: check
the pressure gauge Ref. 1 Fig. 28.
- Switch off the machine press Ref. 2 Fig. 28: in this way the machine stops after idle time running
- Switch off the main switch, Ref. 3 (on the screw-compressor) and Ref. 4 (on the dryer if fitted) Fig. 28
- Disconnect the unit from compressed air network Ref. 5 Fig. 28
- Check there is no pressure inside the machine: check the pressure gauge Ref. 1 Fig. 28.
- Remove the oil separator cover Ref. 6 Fig. 28
- Replace oil separator filter and gasket
- Moisturise gaskets with oil.

REPLACING OIL FILTER
- Remove the oil filter Ref. 7 Fig. 28
- Lubricate the filter seals with a little oil before fitting.
- Tightening must be done by hand.



4
FIG. 28
3


5
1






6













2
7