Instructions / Assembly

13
EN
TROUBLESHOOTING GUIDE (CONTINUED)
PROBLEM POSSIBLE CAUSE SOLUTION
Runs but not cooling
A door or window is open. Make sure the window or door is closed.
The dust filter is dirty. Clean the dust filter.
The exhaust hose is
detached.
Reinstall exhaust hose properly
(refer to Installation section).
Temperature setting is too
high.
Reduce temperature setting on control panel.
Air outlet or intake is
blocked.
Remove blockage.
Room exceeds
recommended size.
Move unit to smaller room.
Large size or number of
windows are decreasing
cooling effectiveness.
Cover windows with curtains or blinds.
Will not run and
Power button is
blinking (water full
indicator)
Excess water
condensation inside
the tank.
Drain the water (refer to Water Condensation Drainage).
Heater* is not
switching ON
(This may only
be applicable for
Quilo
TM
Portable Air
Conditioner models
with built-in Heating
function only).
Heating* function not
activated yet.
The ambient temperature
is too high.
Check that the Heating* function has been activated.
will be illuminated when the Heater is switched ON.
Heating* is activated
only when the ambient
temperature is below 25°C
(77°F).
Switch on the Heating* function when the ambient
temperature reaches below 25°C (77°F).
EN
*Applicable for models with Heating feature only.