Specification

!
• Make sure basecoat plaster is dry before applying adhesive
• Tools, brushes and other application accessories should be
immediately cleaned with water. Use hot water to clean up any
drippings
Use As a Slurry Coat
• Make slurry from approximately 2 parts cement and 1 part
Concrete Bonding Adhesive
• Apply a thin layer of slurry onto the properly prepared substrate
using a trowel, brush or squeegee, being sure to rub the slurry
thoroughly into the surface
• Apply topping or repair material immediately before the slurry
dries
Use As a Primer for Self-Leveling Floor Resurfacers
• Concrete must be free of coatings, curing compounds or waxes
and rigorously clean, dust-free and in sound condition. Use
proper repair techniques to replace unsound concrete with the
appropriate QUIKRETE® repair material. Remove old coatings
and weak surface laitance with appropriate abrasive techniques.
Shotblasting of the surface is most preferred.
• Dilute 1 part QUIKRETE® Concrete Bonding Adhesive with 2
parts clean water. Stir well before using
• Apply with broom, roller or garden sprayer to saturate the
surface. Clean tools and equipment immediately with warm soapy
water
• Low porosity concrete in good condition requires 1 coat. Porous
concrete requires 2 coats
• Do not apply QUIKRETE® Self-Leveling Floor Resurfacer until
the QUIKRETE® Concrete Bonding Adhesive is dry to the touch.
If there is no visible sheen to the concrete, apply a second coat of
QUIKRETE® Concrete Bonding Adhesive and wait for it to dry. A
drying time of 2 - 3 hours is typical, although drying times will vary
greatly with temperature, humidity and the condition of the
concrete
• If the area coated with QUIKRETE® Concrete Bonding
Adhesive is kept clean and dry, the topping can be applied up to
48 hours after installation of the QUIKRETE® Concrete Bonding
Adhesive
PRECAUTIONS
• Protect QUIKRETE Concrete Bonding Adhesive from freezing
• Do not apply at temperatures below 50˚ F (10˚ C)
• Do not use over previously painted surfaces
• Do not use in combination with QUIKRETE Concrete Acrylic
Fortifier
• Do not store in areas over 100˚ F (38˚ C)
AVAILABILITY
QUIKRETE® Concrete Bonding Adhesive is available at leading
concrete construction supply houses and distributors. Contact
QUIKRETE® Construction Products representative for the name
of the nearest dealer.
WARRANTY
The QUIKRETE® Companies warrant this product to be of
merchantable quality when used or applied in accordance with
the
instructions herein. The product is not warranted as suitable
for any purpose or use other than the general purpose for which it
is intended. Liability under this warranty is limited to the
replacement of its product (as purchased) found to be defective,
or at the shipping companies’ option, to refund the purchase
price. In the event of a claim under this warranty, notice must be
given to The QUIKRETE® Companies in writing. This limited
warranty is issued and accepted in lieu of all other express
warranties and expressly excludes liability for consequential
damages.
MAINTENANCE
None required.
TECHNICAL SERVICES
The QUIKRETE® Companies maintain technical field
representatives throughout the country. Contact a local
distributor for the name and number of the nearest
representative, or call QUIKRETE® Construction Products.
The QUIKRETE® Companies
One Securities Centre
3490 Piedmont Rd., NE, Suite 1300
Atlanta, GA 30305
[phone]
Fax: [phone]
www.quikrete.com
!
* Refer to www.quikrete.com for
the most current technical data,
MSDS, and guide specifications
!
Concrete Acrylic Fortifier
Product No. 8610
!
!
!