MSDS

ManualsBrandsQuikrete ManualsBuilding materials10 oz. Stucco Repair

ACRYLIC STUCCO & CRACK REPAIR

MATERIAL SAFETY DATA SHEET

(Complies with OSHA 29 CFR 1910.1200)

SECTION I: PRODUCT IDENTIFICATION

The QUIKRETE

Companies Emergency Telephone Number

One Securities Centre (770) 216-9580

3490 Piedmont Road, Suite 1300

Atlanta, GA 30329 Information Telephone Number

(770) 216-9580

MSDS A2

Revision: Feb-10

QUIKRETE

Product Name Product #

LIQUID STUCCO SWIRL 1320, FINE 1321, COARSE 1322

STUCCO CRACK REPAIR 8650

PREMIXED STUCCO PATCH 8650-32

PRODUCT USAGE: ACRYLIC EXTERIOR COATING AND REPAIR MATERIAL.

SECTION II - HAZARD IDENTIFICATION

Route(s) of Entry: Inhalation, ingestion, skin

Acute Exposure: Inhalation of vapor or mist can cause the following: headache, nausea, irritation

of nose, throat and lungs. Direct contact with eyes can cause irritation and possible corneal injury.

Chronic Exposure: None known

Carcinogenicity: Not carcinogenic

Carcinogenicity Listings: Not applicable

Medical Conditions Generally Aggravated by Exposure: None known

SECTION III - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION

Hazardous Components CAS No. PEL (OSHA) TLV (ACGIH)

mg/M

Limestone/Marble 1317-65-3 5 5

Acrylic Polymer Not Hazardous None None

Clay 12174-11-7 15 10

Titanium Dioxide 13463-67-7 15 10

Ethylene Glycol 107-21-1 50 ppm

(1)

50 ppm

(1)

Limits for Vapor & Mist

Summary of content (5 pages)

PAGE 1
ACRYLIC STUCCO & CRACK REPAIR MATERIAL SAFETY DATA SHEET (Complies with OSHA 29 CFR 1910.
PAGE 2
SECTION IV – First Aid Measures Eyes: Immediately flush eye thoroughly with water – do not rub eyes. Continue flushing eye for at least 15 minutes, including under lids, to remove all particles. Call physician immediately. Skin: Wash skin with cool water and pH-neutral soap or a mild detergent. Seek medical treatment if irritation or inflammation develops or persists. Inhalation: Remove person to fresh air. If coughing and other symptoms develop, seek medical attention.
PAGE 3
SECTION X - REACTIVITY DATA Stability: This material is considered stable. Avoid temperatures above 177oC (350oF), the onset of polymeric decomposition. Thermal decomposition is dependent on time and temperature. Incompatibility (Materials to Avoid): Avoid contact with strong oxidizing agents or strong alkalis. Hazardous Decomposition or By-products: Thermal decomposition may yield acrylic monomers Hazardous Polymerization: Will Not Occur.
PAGE 4
SECTION XV – OTHER REGULATORY INFORMATION US OSHA 29CFR 1910.
PAGE 5
OSHA PEL RCRA SARA TLV TWA WHMIS Occupational Safety and Health Administration Permissible Exposure Limit Resource Conservation and Recovery Act Superfund Amendments and Reauthorization Act Threshold Limit Value Time-weighted Average Workplace Hazardous Material Information System Revision #07-01, supersedes all previous revisions. Created: 10/25/2006 Last Updated: February 23, 2010 NOTE: The information and recommendations contained herein are based upon data believed to be correct.