Installation Guide

4 = Life threatening, major or permanent damage possible
Flammability- 0 = Material will not burn
1 = Material must be preheated before ignition will occur
2 = Material must be exposed to high temperatures before ignition
3 = Material capable of ignition under normal temperatures
4 = Flammable gases or very volatile liquids; may ignite spontaneously
Physical Hazard- 0 = Material is normally stable, even under fire conditions
1 = Material normally stable but may become unstable at high temps
2 = Materials that are unstable and may undergo react at room temp
3 = Materials that may form explosive mixtures with water
4 = Materials that are readily capable of explosive water reaction
Abbreviations:
ACGIH American Conference of Government Industrial Hygienists
CAS Chemical Abstract Service
CERCLA Comprehensive Environmental Response, Compensation & Liability Act
CFR Code of Federal Regulations
CPR Controlled Products Regulations (Canada)
DOT Department of Transportation
IARC International Agency for Research
MSHA Mine Safety and Health Administration
NIOSH National Institute for Occupational Safety and Health
NTP National Toxicity Program
OSHA Occupational Safety and Health Administration
PEL Permissible Exposure Limit
RCRA Resource Conservation and Recovery Act
SARA Superfund Amendments and Reauthorization Act
TLV Threshold Limit Value
TWA Time-weighted Average
WHMIS Workplace Hazardous Material Information System
Revision #10-01, supersedes all previous revisions
Created: 10/25/2006
Last Updated: February 23, 2010
NOTE: The information and recommendations contained herein are based upon data believed to
be correct. However, no guarantee or warranty of any kind, express or implied, is made with
respect to the information contained herein. We accept no responsibility and disclaim all liability for
any harmful effects which may be caused by exposure to silica contained in our products.