Technical Data

mold. Pat and smooth the surface with a trowel.
3. Remove the mold promptly, and smooth the concrete edges with a
trowel until the desired appearance is obtained.
4. Place the mold adjacent to the completed section and continue this
process until your project is completed. By alternately rotating the
Walk Maker® mold one quarter turn each time, a variation in the
pattern is achieved.
5. If desired, QUIKRETE® Sand Mix or Mortar Mix can be applied dry
to the hardened concrete to fill the joints. Brush or sweep the dry mix
into the joints and moisten.
6. To protect your finish, use QUIKRETE® Acrylic Concrete Sealer.
Concrete Sealer provides a water-resistant coating and also protects
concrete surfaces from the deteriorating effects of grease, oil, salt,
and most household chemicals.
Adding Color and Surface Texture
1. Color may be added to any Walk Maker® project with QUIKRETE®
Liquid Cement Color. Ten ounces of liquid color should be used for
every two 60 or 80 lb. Bags of any QUIKRETE® Concrete Mix.
2. Mix 1-1/4 gallons of clean water for every 10 ounces of color. When
using a mechanical mixer add both liquids to the mixer and then add
the concrete mix. When hand-mixing in a tub or wheelbarrow, mix the
color and water, and then add the liquid to the concrete mix.