Installation Guide

CURING
No special curing procedures are required under normal conditions. In
hot, dry or windy conditions keep the patch covered and damp for at
least 24 hours, or apply QUIKRETE
®
Acrylic Concrete Cure and Seal
(No. 87300) in accordance with package instructions.
AGGREGATE EXTENSION
For deep patches, QUIKRETE
®
Rapid Road Repair
®
may be
extended 50% with up to 25 lb (11.3 kg) of minus ½ in (13 mm)
coarse aggregate per 50 lb (22.6 kg) bag. At 50% extension, the
typical yield will be 0.6 cubic feet (17 L). Use well graded, good
quality coarse aggregate, minus ½ in (13 mm) diameter, meeting
ASTM C 33. When extended 100% with this coarse aggregate, each
100 lb (45.3 kg) of 50/50 blend will yield approximately 0.73 cubic feet
(20.6 L). Extension by 100% will affect set time and reduce
compressive strengths compared to data presented in Table 2.
Performance and yield will be affected by the characteristics of the
coarse aggregate utilized and water addition. Adjust water to achieve
a slump of about 3 in to 5 in (75 to 125 mm).
PRECAUTIONS
Do not use if temperatures are below 40 °F ( 4 °C ) or are expected
to go below 32 °F ( 0 °C ) within a 24 hour period. Use cold water in
hot weather or hot water in cold weather to achieve desired product
temperature.
WARRANTY
The QUIKRETE
®
Companies warrant this product to be of
merchantable quality when used or applied in accordance with the
instructions herein. The product is not warranted as suitable for any
purpose or use other than the general purpose for which it is
intended. Liability under this warranty is limited to the replacement of
its product (as purchased) found to be defective, or at the shipping
companies’ option, to refund the purchase price. In the event of a
claim under this warranty, notice must be given to The QUIKRETE®
Companies in writing. This limited warranty is issued and accepted in
lieu of all other express warranties and expressly excludes liability for
consequential damages.
The QUIKRETE
®
Companies
One Securities Centre
3490 Piedmont Rd., NE, Suite 1300, Atlanta, GA 30305
[phone] • Fax: [phone]
* Refer to www.quikrete.com for the most current technical data, SDS, and guide specifications