SDS

ONE SECURITIES CENTRE, 3490 PIEDMONT ROAD, SUITE 1300, ATLANTA, GA 30305 SDS B1 TEL [phone] WWW.QUIKRETE.COM
Page 4 of 9
SECTION V - FIRE FIGHTING MEASURES
5.1 Flammability of the Product: Non-flammable and non-combustible
5.2 Suitable extinguishing agents: Treat for surrounding material
5.3 Special hazards arising from the substance or mixture: None
5.3a Products of Combustion: None
5.3b Explosion Hazards in Presence of Various Substances: Non-explosive in presence of
shocks
SECTION VI – ACCIDENTAL RELEASE MEASURES
6.1 Personal precautions, protective equipment and emergency procedures: Wear personal
protective equipment (See section VIII). Keep unprotected persons away.
6.2 Methods and material for containment and cleaning up:
Do not allow to enter sewers/ surface or ground water. Dispose of unwanted materials and
containers properly in accordance with all regulations.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND STORAGE
7.1 Handling
Precautions for safe handling: Do not use for sand blasting. There are extensive OSHA
precautions required for sand blasting. Ensure good ventilation/exhaustion at the workplace. DO
NOT BREATHE DUST. In dusty environments, the use of an OSHA, MSHA or NIOSH approved
respirator and tight fitting goggles is recommended. Wear appropriate PPE (See section 8).Do not
mix with other chemical products, except as indicated by the manufacturer. Do not get in eyes, on
skin or clothing. Good housekeeping is important to prevent accumulation of dust.
7.2 Storage
Requirements to be met by storerooms and receptacles: No special requirements.
Information about storage in one common storage facility: Not required.
Further information about storage conditions: Keep out of the reach of children.
SECTION VIII – EXPOSURE CONTROL MEASURES / PERSONAL PROTECTION
8.1 Components with limit values that require monitoring at the workplace:
Hazardous Components CAS No. PEL (OSHA) TLV (ACGIH)
mg/M
3
mg/M
3
Silica Sand, crystalline 14808-60-7 0.1 0.025 (resp)
8.2 Exposure Controls
Use ventilation adequate to keep exposures below recommended exposure limits.