Installation Guide



APPLICATION
• Shovel or place concrete into form. Fill to the full depth of the form.
Start in a corner and do not drag or flow the concrete unnecessarily
• After the concrete has been spread to completely fill the forms,
strike off and float immediately
• To strike off, simply use a straight board, moving the edge back and
forth with a saw-like motion to smooth the surface. Then use a darby
or bull float to float the surface. This helps level any ridges and fills
voids left by the straight edge
• Allow the concrete to stiffen slightly, waiting until all water has
evaporated from the surface before troweling or applying a broom
finish
Note - For best results, do not overwork the material. QUIKRETE
®
Fast-Setting Concrete can be walked on in 2 hours. Wait at least 4
hours before placing heavy objects on the slab.
CURING
GENERAL
Curing is one of the most important steps in concrete construction.
Proper curing increases the strength and durability of concrete.
Proper water content and temperature are essential for good curing.
In near freezing temperatures, the hydration process slows
considerably. When weather is too hot, dry or windy, water is lost by
evaporation from the concrete and hydration stops, resulting in
finishing difficulties and cracks. The ideal circumstances for curing are
ample moisture and moderate temperature and wind conditions.
SPECIFIC METHODS
Because QUIKRETE
®
Fast-Setting Concrete is often used a few
hours after placement, initial curing is very important. The most
convenient curing method is to cover the concrete with plastic.
PRECAUTIONS
• Mix only as much material as can be placed in 20 minutes.
• Because of the rapid setting time, special precautions must be
taken, as set times will fluctuate in extremely hot or cold weather. Use
cold water or water mixed with ice cubes in severely hot weather. Use
hot water when mixing in severely cold weather.
WARRANTY
The QUIKRETE
®
Companies warrant this product to be of
merchantable quality when used or applied in accordance with the
instructions herein. The product is not warranted as suitable for any
purpose or use other than the general purpose for which it is
intended. Liability under this warranty is limited to the replacement of
its product (as purchased) found to be defective, or at the shipping
companies’ option, to refund the purchase price. In the event of a
claim under this warranty, notice must be given to The QUIKRETE
®
Companies in writing. This limited warranty is issued and accepted in
lieu of all other express warranties and expressly excludes liability for
consequential damages.
The QUIKRETE
®
Companies
One Securities Centre
3490 Piedmont Rd., NE, Suite 1300, Atlanta, GA 30305
[phone] • Fax: [phone]

* Refer to www.quikrete.com for the most current technical data, MSDS, and guide specifications
