Installation Guide

The QuietWarmth
®
Peel & Stick Radiant Heat system works just like the sun. When the thermostat calls for power,
the heating element warms the floor’s surface by providing radiant heat, the same type of heat that warms you on
a cool spring day. Although the air is cool, the radiant heat from the sun keeps you warm.
The radiant heat warms your floor, and provides clean even heat throughout the room by uniformly warming the
objects while providing thermal comfort. There is no need to directly over-heat the air. This is the opposite of how
a conventional forced hot air or baseboard heating systems works. In other types of heating systems, the large
mass of air in a home is heated while the objects and especially the outside walls remain relatively cool.
Read and follow all the installation instructions in this manual before attempting to install
QuietWarmth Peel & Stick Radiant Heat. Improper installation procedures or techniques can
cause potentially unsafe conditions, including overheating and shock hazards.
Failure to comply with the instructions in this manual can void the manufacturer’s warranty.
Electrical connections should only be made by licensed contractors.
The heating product shall not be installed in closets, over walls or partitions that extend to the
ceiling, or over cabinets whose clearance from the ceiling is less than the minimum horizontal
dimension of the cabinet to the nearest cabinet edge that is open to the room or area.
This product is not to be installed in contact with combustible surfaces.The intended use of this
product is for floor warming underneath tile, stone and marble floor coverings.
PEEL & STICK RadIanT HEaT foR TILE fLooRS
INSTALLATION AND OPERATION
CAUTION