Installation Guide

The QuietWarmth Radiant Heat for Floating Floors system works just like the sun. When the thermostat calls for
power, the heating element warms the floating floor or laminate finished flooring surface by providing radiant
heat, the same type of heat that warms you on a cool spring day. Although the air is cool, the radiant heat from
the sun keeps you warm.
The radiant heat warms your floor, and provides clean even heat throughout the room by uniformly warming the
objects while providing thermal comfort. There is no need to directly over-heat the air. This is the opposite of how
a conventional forced hot air or baseboard heating systems works. In other types of heating systems, the large
mass of air in a home is heated while the objects and especially the outside walls remain relatively cool.
CAUTION:
Read and follow all the installation instructions in this manual before attempting
to install the QuietWarmth Radiant Heat for Floating Floors. Improper installation
procedures or techniques can cause potentially unsafe conditions, including
overheating and shock hazards. Failure to comply with the instructions in this
manual can void the manufacturer’s warranty. Electrical connections should
only be made by licensed contractors.
NOTE:
Upon removing the heating mats from the box, it is important to check and record
the resistance of each mat using a digital ohmmeter, and compare those readings
with the baseline resistance indicated on the stickers attached to the mats. If
any mat shows a resistance reading that varies from the baseline value, call the
technical support hotline at 1-888-WARM PAD.
RADIANT HEAT FILM FOR FLOATING FLOORS
INSTALLATION AND OPERATION