Owner`s manual

P roblem (continued)
2. Found water on floor after
overnight shut off .
3. Foul odor from fan
A. New Unit . . .
B. After normal use . . .
4. No water running over the
pads . . .
5. Scale build - up on cooling pads.
C ause (continued)
Leak ing from bottom of pads .
Excessive water pressure .
Float valve maybe stuck in open position.
New pad may ha ve a temporary odor (this
is normal) – you may be smelling the
thermosetting resin – it will pass.
Water quality – check your immediate
environment .
Check your water flow valve first.
Water supply off at main valve source.
Pump switch is off.
Water filter may be clogged.
Hard water with excessive mineral content.
S olution (continued)
Push bottom of cooling pads gently inside to
stop leaking .
Check you pressure. Max water pressure is 413
KPA (60 p.s.i.), adjust water supply valve to
1 ¼ turns or install a water pressure regulator
found at local hardware store.
Conta minants in water; drain cooler, sump and
refill. If float remains stuck remove pads and
examine float for debris or damage. Wash out
debris and replace float . Continue.
Drain and refill several times in first week to
remove thermosetting resin smell.
Add QC Tablets to reduce smell – and algae.
Water should b e drained about once a month or
sooner depending on your specific working
environment – the water quality and conditions.
Make sure your water flow valve is open.
QuietCool units usually operate at peak
performance at 1 ¼ turns.
Open water valve at sup ply. You may wish to
keep this valve open at all times.
Turn pump switch on.
Remove the cooling pads see section 6.2. Open
back of unit – open water filter – pull out filter
screen and clean. Replace and try again.
Use Evapo -O- Matic Tablets or add a W ater
S tabilizer at the discharge side of the pump .
See Accessories section 9.0.
Flush water from unit’s water reservoir more
frequently. See section 7.4.
8 .0 Storage
Remove pads as described above in 7.2 and rinse pads clean with fresh water. Dry co oling pads in sunlight. Drain water
reservoir completely and wipe dry. Replace dry cooling pads. Replace top angle bar to hold pads in place. Store QuietCool
in dry, clean area and cover (you can order a QCCover for your unit – see section 9.0) to prevent dust build up to have unit
ready for the next hot season. Note : Make a list of accessories and needed par ts – purchase off - season to save mone y.