Instructions / Assembly

1-888-QUIETCOOL

3. From below, place the cut-out template on the ceiling,

making sure that you have at least 2 inches of

clearance all around it. While holding the template in

place, mark its outline with a pencil.

4. Using a drywall saw or similar device, cut out the hole

in the ceiling.

5. Open and unpack your QuietCool fan.

TIP: If your attic is very tight, you may want

to wire your QuietCool motor housing before

bringing it into the attic. Please follow the wiring diagrams that start on page 13.

6. Take the main assembly, which includes the motor

housing, damper box, and duct into the attic through

the crawl hole and move into position near the ceiling

cut-out hole.

TIP: If your attic access is far from your fan

location, you can remove the duct from the motor

housing and pass the motor housing, duct, and

damper box through the ceiling cut out hole and

reattach the duct to the motor housing in the

attic.

7. Pre-screw two wood screws into the rafter almost all the way. Using the new hanger strap with eyelet

holes, hang the motor head from the two wood screws and tighten the screws. Make sure that the

handy box on the motor head is at the very top. Secure duct to damper box using three black sharp

screws. Make sure the housing is angeled slightly up and the duct has a gentle 90 degree bend to

help reduce noise level. The angle is important so the fan does not disturb any blown-in insulation in

your attic.

NOTE: Once your QuietCool fan is hung, it’s time to go below and install the damper box and

ceiling grille.