Installation Instructions

1-888-QUIETCOOL

Option #2 - Install the Hub over the handybox:

1. Remove the handy box cover on your QuietCool fan.

2. Remove the wire nuts from the power cord and motor wires inside the handy box.

Remove the ground screw.

3. Using your flat-head screwdriver,

open up the Hub.

4. Using your flat-head screwdriver,

remove the knockouts shown in the

diagram to the right.

5. Run the power cord and motor

leads into the Hub.

6. Using the two plate screws, mount

the Hub to the handy box using the highlighted screw holes above.

NOTE: If you are retrofitting this control on an existing QuietCool, it may be

easier to use Option #2.

2-2 Wiring the Hub

IMPORTANT: The wiring is different depending on if you are wiring a Energy

Saver/Stealth Pro fan or a Classic/Trident Pro fan. Please follow the proper

wiring diagram for your type of QuietCool fan model.

NOTE: Wiring Diagrams are for examples only and wiring should be done

by an experienced electrician. 12 or 14-gauge romex is common. Check your

local building code before choosing the wire type.

NOTE: Ensure the power is disconnected before performing any wiring

connections.

NOTE: The wiring diagrams and instructions are shown using the power cord

included with your QuietCool. The installation can also be performed with

2-wire romex and hard wired.