Instructions / Assembly

1-888-QUIETCOOL 10
3. WIRING
IMPORTANT: Wiring Diagrams are for examples ONLY. Wiring should be done by a licensed
electrician following local building and electrical codes and/or NEC guidelines.
NOTE: Your fan came with the thermostat pre-wired to a power cord for testing purposes before
installation. If you would like to hard-wire the fan, or it is required by your local building codes,
please follow the wiring instructions below.
!!
!!
3.1 THERMOSTAT WIRING
1. For this installation, you will need a 2 wire Romex, and a thermostat.
2. Open up the thermostat that is connected to the fan. Remove the power cord. Bring your 2 wire
Romex from the power source into the thermostat.
3. With a wire nut, tie the white common wires together.
4. High Speed: Tie the black wire from the fan to one of the black wires from the thermostat. Cap the
red wire (see Figure 3.1A)
Low Speed: Tie the red wire from the fan to one of the black wires from the thermostat. Cap the
black wire (see Figure 3.1B)
5. Tie the black wire from the power source to the remaining black wire from the thermostat.
6. Using the ground screw in the thermostat, ground your power source and the green wire from the
fan.
7. Mount the thermostat to one of the joists near the attic fan.
Ground the fan and power to the thermostat
using the green ground screw
Specialty Series Fan
Power Source
14-2 Wire
2 Wire Romex
Thermostat
Low Speed
High Speed
Figure 3.1A