Instructions / Assembly

ManualsBrandsQuietCool ManualsBuilding materialsQuietCool 2116 CFM Smart App Controlled 3-Speed Roof Mount Attic Fan

QUIETCOOLSYSTEMS.COM 9

12. Apply weatherproof sealant to the seam between the AFR

fan housing and primary ashing. This seam must be sealed

to create a weatherproof barrier between the fan and the

ashing. (see Figure 2.2G)

NOTE: This seam exists to allow the use of interchangeable

ashings. If this seam is not sealed, water may leak in

between the fan housing and the ashing. Be sure to use

a generous amount of weatherproof sealant to create a

watertight seal.

13. Using the QuietCool Secondary Flashing accessory (part

number FLA-SEC-3743), gently slide the ashing over the fan

housing and hood mounting tabs. (see Figure 2.2H)

NOTE: The secondary ashing was designed to work with

almost all types of tile and cement roofs. The ashing can

be molded to create the shapes of more unique style roofs

such as S-Tile and M-Tile.

NOTE: Be sure that the secondary ashing extends onto

the roof tile at the bottom of the ashing. This ensures that

water cannot leak in between roof tiles.

15. Form the secondary ashing to close the gap between the

ashing and the fan housing. The aluminum is very malleable

so this should be done easily using your hands. Using

weatherproof sealant, seal the gap between the fan housing

and secondary ashing. (see Figure 2.2I)

16. Bend the left and right side edge of the secondary ashing

at a 90º angle to create a water channel on either side of the

ashing. This will help direct water to ow down and back onto

the roof rather than side to side under the tiles. (see Figure

2.2J)

17. Using an angle grinder, cut the removed tiles to t them to the

shape of the fan and secondary ashing. (see Figure 2.2K)

18. Re-install the tile around the fan unit. (see Figure 2.2L)

19. Apply weatherproof sealant on the bottom side of the

secondary ashing to secure the ashing to the roof tile.(see

Figure 2.2M)

20. Re-install the hood onto the fan unit and remove the

protective lm.

WELCOME

INSTALLATION

WIRING OPERATION

WARRANTY

Figure 2.2G

Figure 2.2H

Figure 2.2I

Figure 2.2J

Figure 2.2K

Figure 2.2L

Figure 2.2M