Instructions / Assembly
QUIETCOOLSYSTEMS.COM 7
Figure 2.1G
Figure 2.1H
10. Using a minimum of 8 roong nails, nail the fan to
the roof through the primary ashing, securing the
fan to the roof. To prevent leaking, be sure to apply
weatherproof sealant on the nail heads. (see Figure
2.1G)
11. Secure the shingles by re-nailing them into the roof
and applying weatherproof sealant. (See Figure 2.1H
& I)
12. Apply weatherproof sealant to the seam between the
AFR fan housing and primary ashing. This seam must
be sealed to create a weatherproof barrier between
the fan and the ashing. (see Figure 2.1J)
NOTE: This seam exists to allow the use of
interchangeable ashings. If this seam is not sealed,
water may leak in between the fan housing and
the ashing. Be sure to use a generous amount of
weatherproof sealant to create a watertight seal.
13. Re-install the hood onto the fan unit and remove
protective lm. (see Figure 2.1K)
Figure 2.1I
Figure 2.1K
Figure 2.1J
WELCOME
INSTALLATION
WIRING OPERATION
WARRANTY
!!