AFG SMT Owner's Guide

1-888-QUIETCOOL

2.2 INSTALLING AFG VENT COVERS

Included with your QuietCool Attic Gable Fan are four vent covers

that are designed to be installed around the attic fan housing to

block any air backdrafting into the attic through a gable vent that

is larger than the attic fan cylinder, causing air to cycle in and out

around the vent.

1. Take the vent cover and match it to one of the sides around

the attic fan housing.

2. Using the two provided screws, attach each corner to the

wood framing around your gable vent. (See picture for screw

locations)

3. Repeat step 1 and 2 for the three additional covers.

Figure 2.1A

Figure 2.1B

NOTE: Wiring Diagrams are for examples ONLY. Wiring should be done by an

experienced electrician.

NOTE: Your fan came with the Smart Control Hub pre-wired to a power cord for testing purposes

before installation. If you would like to hard-wire the fan, or it is required by your local building

codes, please follow the wiring instructions below.

Installation Video:

Watch the video by scanning the QR

code or visit