Technical Specifications

TOOLS
Name Part Number Description
•Combination FCT-104 Used to attach electrical
Crimping Tool connectors to the heating panels
and wires to the connectors.
Manufactured by Harbin Sanzing
Calorique Heating Company, Ltd.
Staple Gun Standard automatic stapler. Used
to attach Calorique panels to ceil-
ing joists. Recommended staple
length: 5/16 or 3/8 inch / 8 or
9.5 mm.
Assorted Hand Tools Conventional electrical wiring
hand tools.
Knife and/or Scissors Used to cut heating panel sets
from the supply roll.
PART 3 - INSTALLATION
INSTALL CONTROL DEVICE BOX
Install a junction box for the control device. If this device is a
thermostat, the box should be located, unobstructed, on an
inside wall so that the device reads accurately.
PREPARE THE HEATING PANELS
Prepare all heating panels for each room at one time prior to starting
installation.
1. Cut the panel(s) to length.
Using a knife or scissors, cut panel sets according the layout
made in Part 1.
2. Attach connectors to one end of each heating panel set.
Center a connector over one end of each bus bar, pressing them
in place with finger pressure and then crimp each connector in
place using the flat portion of the crimping tool as shown in the
following figure.
INSTALLATION

Calorique radiant
heating panels must
be installed as out-
lined in these instruc-
tions.

Nominal spacing
when the crimping
tool is fully closed is
0.095 inch (2.4 mm).
7

Cut heating panels
only along the
dashed “cut here”
lines.

Use only
those crimp-
ing tools
specifically provided
by Calorique.
Crimping Tool
Connector
Bus Bar
Heating Panel
CM1004 FLOOR - 2003-09-16.qxd 9/17/2003 2:59 PM Page 9