Technical Specifications

ManualsBrandsQuiet Warmth ManualsElectric In-Floor HeatingProgrammable WIFI Touchscreen Thermostat with Floor Sensor Underlayment

WIRE THE HEATING PANEL SETS

Wire the heating panels in parallel according to the following figures.

Repeat the steps for each electrical connector.

1. Strip the non-heating lead wires (s) that will be attached to the

connector. Strip about 1/4 inch / 6 mm.

2. Insert the wire(s) into the barrel section of the connector.

3. Crimp the wires in place using the barrel crimping section of the

crimping tool as shown in the following figure.

INSPECTION • TESTING • COMPLETION



WARNING-

RISK OF

ELECTRIC

SHOCK AND FIRE

DAMAGE TO THE

SUPPLY CONDUC-

TOR INSULATION

MAY OCCUR IF

CONDUCTORS ARE

ROUTED LESS

THAN 2 INCHES

(51 MM) FROM

THIS HEATING

PRODUCT. REFER

TO INSTALLATION

INSTRUCTIONS

FOR FOR RECOM-

MENDED MEANS

OF ROUTING SUP-

PLY CONDUC-

TORS.



Route and secure

wires between the

heating panels, from

the heating panels to

the thermostat box

and from the thermo-

stat box to the electri-

cal panel using stan-

dard wiring practices

that conform to all of

the requirements of

all applicable electri-

cal and building

codes.

To Control Device

Non-Heating Leads

CM1004 FLOOR - 2003-09-16.qxd 9/17/2003 2:59 PM Page 13