Technical Specifications

Floor Heating Panels and Ceiling Heating Panels Installed in the Same
Joist Space
• If access is from above, completely install the radiant ceiling heat-
ing system (including wiring and testing), insulate above the panel
sets and then completely install the floor heating system.
• If access is from below, completely install the floor heating system
(including wiring and testing), insulate below the heaters and then
completely install the ceiling heating system.
• Repeat for each heating panel set, then continue to the next sec-
tion, Wire the Heating Panel Sets.
INSPECTION • TESTING • COMPLETION
10
Complementary Heating Products
Ceiling Heating Products RCH13P13W240V RCH17P17W240V RCH25P25W240V
Floor Warming Products 17 W/SF 17 W/SF 17W/SF
FLR13P8W120V 10 W/SF complementary complementary complementary
FLR13P8W240V 10 W/SF complementary complementary complementary
FLR17P10W120V 10 W/SF complementary complementary complementary
FLR17P10W240V 10 W/SF complementary complementary complementary
FLR25P17W120V 10 W/SF complementary complementary complementary
FLR25P17W240V 10 W/SF complementary complementary complementary
NOTE
INTENDED FOR INSTALLATION IN A COMMON JOIST SPACE WITH
COMPLEMENTARY CEILING HEATING PRODUCT RATED 17 WATTS
PER SQUARE FOOT MAXIMUM. See the Complementary Heating
Products table below for a list of heating elements that may be
used tin the same joist space.

Use at least 3 inches
/ 75 mm of unfaced
fiberglass insulation
to insulate between
the heating panel
sets of the two sys-
tems. If joists are
greater than 6 inches
/ 150 mm in depth
thicker insulation
must be used to
avoid air pockets
above the ceiling
heating panel sets.

See the Calorique
Ceiling Heating
System installation
manual for complete
details on the instal-
lation and testing of
that system.


CM1004 FLOOR - 2003-09-16.qxd 9/17/2003 2:59 PM Page 12