Instructions / Assembly

4/1/13
• Rolling Door Instructions
Roller Strap Installation
1. Install the roller straps onto the top edge of the door. The
location of these straps is critical for the proper, safe use of the
rolling door.
2. The distance between the top of the door and the outer diameter of the
back of the wheel (measured from the back of the door) should be 13/16”
– 7/8” (this will achieve approximately 3/32” gap between the top of the
door and the rail when these measurements are achieved).
3. Using the screws provided attach the strap to the door. It is very
important that the screws are installed into solid wood, not hollow-core
doors with thin veneer skins. It is also recommended that you predrill
the screw holes. Make sure that proper vertical alignment of the strap
is achieved before fastening the strap to the door.
Rail Installation
1. The location of the rail is dependent on the height of the door, desired
gap between the  oor and bottom of door and desired overlay of top of the
door to door opening.
2. Recommended spacing for the wall mounted brackets is 16”
3. The Short Bracket will accommodate doors up to 1-1/2” thick,
the Long Bracket will accommodate doors up to 2-1/4” thick.
4. Wall brackets must be mounted securely into the studs behind the sheetrock.
If the brackets are to be mounted to the moulding surrounding the
opening, the moulding must be  rmly secured to the wall framework.
End Stops and Center Guide ( oor mounted & wall mounted)
1. After installing the door onto the rail, slide the door to the desired
opened position.
2. Install the End Stop bracket to the  oor or wall so that the door stops in the
desired opened position.
3. Install the Center Guide bracket so that the door will always be
captured by this bracket in the fully opened and fully closed position.
4. Repeat step #2 for installation of the other End Stop bracket when the
door is in the closed position.
Dimensional Speci cations
Gap between the wall and the door
Using the Short Bracket: Door thickness – 1-7/8” = gap
Using the Long Bracket: Door Thickness – 2-1/2” = gap
13/16” - 7/8”
3/32”
Gap
5/8”
Gap between
wall and door
23/32”
2”CC
2-5/8”
Protrusion
2-3/8”
1-3/4”
7/8”
Long Bracket
1”
1-25/32”
2-5/8”
Protrusion
1-3/4”
1-3/4”
7/8”
Short Bracket
13/16” - 7/8”