Specification

3
2. To splice rails together using the Quiet Glide splice kit (QG.41) complete the following steps.
• Insert the roll pin halfway the length of the pin into one of the rails (Figure 1)
• Slide the steel bar halfway into the rail and tighten 2 of the set screws to lock the bar and
roll pin onto the rail (Figure 2)
• Line up the roll pin hole and slot for the steel bar on the other rail and slide the rail over
the pin and bar till a tight connection is made between rails (Figures 3 & 4)
• Complete the splice by tightening the remaining 2 set screws
3. Slide all the brackets onto the rail, recommended spacing of the brackets is
approximately 32” apart.
4. Using the level horizontal line as a guide, secure each bracket to the wood surface
with the included screws.
Figure 4
Figure 2
Figure 3
Figure 1