User guide

Command Line Interface
6-16
6
System Logging Commands
These commands are used to configure system logging on the wireless bridge.
logging on
This command controls logging of error messages; i.e., sending debug or error
messages to memory. The no form disables the logging process.
Syntax
logging on
no logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to memory. You can use
the logging level command to control the type of error messages that are
stored in memory.
Example
Command Function Mode Page
logging on Controls logging of error messages GC 6-16
logging host Adds a syslog server host IP address that will receive logging
messages
GC 6-17
logging console Initiates logging of error messages to the console GC 6-17
logging level Defines the minimum severity level for event logging GC 6-18
logging facility-type Sets the facility type for remote logging of syslog messages GC 6-18
show logging Displays the state of logging Exec 6-19
Outdoor Bridge(config)#logging on
Outdoor Bridge(config)#