User guide

Command Line Interface
6-6
6
Command Groups
The system commands can be broken down into the functional groups shown below.
The access mode shown in the following tables is indicated by these abbreviations:
GC (Global Configuration), and IC (Interface Configuration.
General Commands
Command Group Description Page
General Basic commands for entering configuration mode, restarting the system,
or quitting the CLI
6-6
System Management Controls user name, password, browser management options, and a
variety of other system information
6-10
System Logging Configures system logging parameters 6-16
System Clock Configures SNTP and system clock settings 6-19
SNMP Configures community access strings and trap managers 6-23
Flash/File Manages code image or wireless bridge configuration files 6-27
WDS Configures the Wireless Distribution System forwarding table 6-30
Bridge Configures MAC address table aging time settings and spanning tree
parameters
6-33
Filtering Filters access to the management interface from wireless nodes, and
filters traffic using specific Ethernet protocol types
6-40
Ethernet Interface Configures connection parameters for the Ethernet interface 6-43
Wireless Interface Configures connection parameters for the wireless interface 6-47
VLANs Configures VLAN support 6-58
Command Function Mode Page
configure Activates global configuration mode Exec 6-7
end Returns to the previous configuration mode GC, IC 6-7
exit Returns to Exec mode, or exits the CLI any 6-7
ping Sends ICMP echo request packets to another node on the network Exec 6-8
reset Restarts the system Exec 6-9
show history Shows the command history buffer Exec 6-9
show line Shows the configuration settings for the console port Exec 6-10