User guide

System Configuration
5-32
5
CLI Commands for AES Security – From the 802.11a interface configuration mode,
use the
encryption command to enable AES encryption. To enter AES keys, use the
key command. To view the current security settings, use the show interface wireless
a
command.
Note: The key type value entered using the key command must be the same as the
type specified in the encryption command.
Outdoor Bridge(config)#interface wireless a 6-43
Enter Wireless configuration commands, one per line.
Outdoor Bridge(if-wireless a)#encryption wdsaes alphanumeric 6-53
Outdoor Bridge(if-wireless a)#key wdsaes 1 agoodsecretkey 6-54
Outdoor Bridge(if-wireless a)#exit
Outdoor Bridge#show interface wireless a 6-57
Wireless Interface 802.11g Information
==========================================================
----------------Identification-----------------------------
Description : Enterprise 802.11a Access Point
Turbo Mode : OFF
Channel : 36
Status : Disable
Service type : WDS
----------------802.11 Parameters--------------------------
Transmit Power : FULL (15 dBm)
Max Station Data Rate : 54Mbps
Fragmentation Threshold : 2346 bytes
RTS Threshold : 2347 bytes
Beacon Interval : 100 TUs
DTIM Interval : 2 beacons
----------------Security-----------------------------------
Encryption : 128-BIT AES ENCRYPTION
AES Key type : Alphanumeric
===========================================================
Outdoor Bridge#