User guide

Radio Interface
5-31
5
• Alphanumeric: Enter keys as an alphanumeric string using between 8 and 31
characters.
Note: For each wireless port link (1 to 16), the AES keys must match on the
corresponding bridge unit.
CLI Commands for WEP Security – From the 802.11a interface configuration mode,
use the
encryption command to enable WEP encryption. To enter WEP keys, use the
key command, and then set one key as the transmit key using the transmit-key
command. To view the current security settings, use the
show interface wireless a
command.
Note: The index and length values used in the key command must be the same
values used in the encryption and transmit-key commands.
Outdoor Bridge(config)#interface wireless a 6-43
Enter Wireless configuration commands, one per line.
Outdoor Bridge(if-wireless a)#encryption wep 128 6-53
Outdoor Bridge(if-wireless a)#key wep 1 128 ascii abcdeabcdeabc 6-54
Outdoor Bridge(if-wireless a)#transmit-key 1 6-55
Outdoor Bridge(if-wireless a)#exit
Outdoor Bridge#show interface wireless a 6-57
Wireless Interface 802.11g Information
==========================================================
Description : Enterprise 802.11a Access Point
Turbo Mode : OFF
Channel : 36
Status : Disable
Service type : WDS
----------------802.11 Parameters--------------------------
Transmit Power : FULL (15 dBm)
Max Station Data Rate : 54Mbps
Fragmentation Threshold : 2346 bytes
RTS Threshold : 2347 bytes
Beacon Interval : 100 TUs
DTIM Interval : 2 beacons
----------------Security-----------------------------------
Encryption : 128-BIT WEP ENCRYPTION
WEP Key type : Alphanumeric
Default Transmit Key : 1
Static Keys :
Key 1: ***** Key 2: EMPTY Key 3: EMPTY Key 4: EMPTY
===========================================================
Outdoor Bridge#