User guide

Advanced Configuration
5-9
5
CLI Commands for SNMP – Use the snmp-server enable server command from the
global configuration mode to enable SNMP. To set read/write and read-only
community names, use the snmp-server community command. The snmp-server
host
command defines a trap receiver host. To view the current SNMP settings, use
the
show snmp command.
Outdoor Bridge(config)#snmp-server enable server 6-25
Outdoor Bridge(config)#snmp-server community alpha rw 6-23
Outdoor Bridge(config)#snmp-server community beta ro
Outdoor Bridge(config)#snmp-server host 10.1.19.23 alpha 6-25
Outdoor Bridge(config)#exit
Outdoor Bridge#show snmp 6-26
SNMP Information
============================================
Service State : Enable
Community (ro) : ****
Community (rw) : *****
Location : building-1
Contact : Paul
Traps : Enabled
Host Name/IP : 10.1.19.23
Trap Community : *****
=============================================
Outdoor Bridge#