User guide

Advanced Configuration
5-3
5
System Name – An alias for the wireless bridge, enabling the device to be uniquely
identified on the network. (Default: Outdoor Bridge; Range: 1-22 characters)
Location – A text string that describes the system location. (Maximum length: 20
characters)
Contact – A text string that describes the system contact. (Maximum length: 255
characters)
CLI Commands for System Identification – Enter the global configuration mode and
use the
system name command to specify a new system name. Use the
snmp-server location and snmp-server contact commands to indicate the physical
location of the wireless bridge and define a system contact. Then return to the Exec
mode, and use the show system command to display the changes to the system
identification settings.
TCP / IP Settings
Configuring the wireless bridge with an IP address expands your ability to manage
the wireless bridge. A number of wireless bridge features depend on IP addressing
to operate.
Note: You can use the web browser interface to access IP addressing only if the
wireless bridge already has an IP address that is reachable through your
network.
Outdoor Bridge#configure 6-7
Outdoor Bridge(config)#system name R&D 6-12
Outdoor Bridge(config)#snmp-server location building-1 6-26
Outdoor Bridge(config)#snmp-server contact Paul 6-24
Outdoor Bridge(config)#exit
Outdoor Bridge#show system 6-15
System Information
===================================================
Serial Number : 0000000005
System Up time : 0 days, 0 hours, 35 minutes, 56 seconds
System Name : R&D
System Location : building-1
System Contact : Paul
System Country Code : US - UNITED STATES
MAC Address : 00-30-F1-BE-F4-96
IP Address : 192.168.1.1
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
VLAN State : DISABLED
Native VLAN ID : 1
DHCP Client : ENABLED
HTTP Server : ENABLED
HTTP Server Port : 80
Software Version : v1.1.1.0
===================================================
Outdoor Bridge#