User guide

Initial Configuration
4-6
4
2. IP Configuration – Either enable or disable (Dynamic Host Configuration
Protocol (DHCP) for automatic IP configuration. If you disable DHCP, then
manually enter the IP address and subnet mask. If a management station exists
on another network segment, then you must enter the IP address for a gateway
that can route traffic between these segments. Then enter the IP address for
the primary and secondary Domain Name Servers (DNS) servers to be used for
host-name to IP address resolution.
DHCP Client – With DHCP Client enabled, the IP address, subnet mask and
default gateway can be dynamically assigned to the access point by the
network DHCP server. (Default: Enable)
Note: If there is no DHCP server on your network, then the access point will
automatically start up with its default IP address, 192.168.1.1.