User guide

Hardware Installation
3-8
3
2. Pan the antenna horizontally back and forth by rotating the mounting bracket
around the pole while checking the RSSI voltage.
3. Find the point where the signal is strongest (highest voltage) and secure the
mounting bracket firmly to the pole.
Note: Sometimes there may not be a central lobe peak in the voltage because vertical
alignment is too far off; only two similar peaks for the side lobes are detected. In
this case, fix the antenna halfway between the two peaks.
4. Loosen the vertical adjustment nut on the mounting bracket and tilt the antenna
slowly up and down while checking the RSSI voltage.
5. Find the point where the signal is strongest and secure the vertical adjustment
nut.
6. Remove the voltmeter cable and replace the RSSI connector cover.