User guide

System Defaults

1-7

• Scans all available channels and selects the best channel and data rate based on

the signal-to-noise ratio

• Manageable through an easy-to-use web-browser interface, command line (via

Telnet), or SNMP network management tools

System Defaults

The following table lists some of the wireless bridge’s basic system defaults. To

reset the bridge defaults, use the CLI command “reset configuration” from the Exec

level prompt.

Feature Parameter Default

Identification System Name Outdoor Bridge

Administration User Name admin

Password null

General HTTP Server Enabled

HTTP Server Port 80

TCP/IP IP Address 192.168.1.1

Subnet Mask 255.255.255.0

Default Gateway 0.0.0.0

Primary DNS IP 0.0.0.0

Secondary DNS IP 0.0.0.0

VLANs Status DIsbaled

Native VLAN ID 1

Filter Control Ethernet Type Disabled

SNMP Status Enabled

Location null

Contact Contact

Community (Read Only) public

Community

(Read/Write)

private

Traps Enabled

Trap Destination IP Address null

Trap Destination Community

Name

public