User guide

Command Line Interface
6-44
6
Command Mode
Global Configuration
Command Usage
The primary and secondary name servers are queried in sequence.
Example
This example specifies two domain-name servers.
Related Commands
show interface ethernet (6-46)
ip address
This command sets the IP address for the (10/100Base-TX) Ethernet interface. Use
the no form to restore the default IP address.
Syntax
ip address <ip-address> <netmask> <gateway>
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
• gateway - IP address of the default gateway
Default Setting
IP address: 192.168.1.1
Netmask: 255.255.255.0
Command Mode
Interface Configuration (Ethernet)
Command Usage
• DHCP is enabled by default. To manually configure a new IP address, you
must first disable the DHCP client with the no ip dhcp command.
• You must assign an IP address to this device to gain management access
over the network or to connect the wireless bridge to existing IP subnets.
You can manually configure a specific IP address using this command, or
direct the device to obtain an address from a DHCP server using the ip
dhcp command. Valid IP addresses consist of four numbers, 0 to 255,
separated by periods. Anything outside this format will not be accepted by
the configuration program.
Outdoor Bridge(if-ethernet)#dns primary-server 192.168.1.55
Outdoor Bridge(if-ethernet)#dns secondary-server 10.1.0.55
Outdoor Bridge(if-ethernet)#