User guide

Ethernet Interface Commands
6-43
6
Ethernet Interface Commands
The commands described in this section configure connection parameters for the
Ethernet interface.
interface ethernet
This command enters Ethernet interface configuration mode.
Syntax
interface ethernet
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 10/100Base-TX network interface, enter the following command:
dns server
This command specifies the address for the primary or secondary domain name
server to be used for name-to-address resolution.
Syntax
dns primary-server <server-address>
dns secondary-server <server-address>
• primary-server - Primary server used for name resolution.
• secondary-server - Secondary server used for name resolution.
• server-address - IP address of domain-name server.
Default Setting
None
Command Function Mode Page
interface ethernet Enters Ethernet interface configuration mode GC 6-43
dns primary-server Specifies the primary name server IC-E 6-43
dns secondary-server Specifies the secondary name server IC-E 6-43
ip address Sets the IP address for the Ethernet interface IC-E 6-44
ip dhcp Submits a DHCP request for an IP address IC-E 6-45
shutdown Disables the Ethernet interface IC-E 6-46
show interface ethernet Shows the status for the Ethernet interface Exec 6-46
Outdoor Bridge(config)#interface ethernet
Outdoor Bridge(if-ethernet)#