User guide

Command Line Interface
6-40
6
Example
Filtering Commands
The commands described in this section are used to control access to the
management interface from the wireless interface and filter traffic using specific
Ethernet protocol types.
filter ap-manage
This command prevents access to wireless bridge management from the wireless
interface. Use the no form to disable this filtering.
Syntax
filter ap-manage
no filter ap-manage
Default
Disabled
Outdoor Bridge#show bridge
Bridge Information
=================================================
Media Type | Age Time(sec)|
=================================================
EtherNet | 300 |
WLAN_A | 1000 |
==================================================
Bridge Id : 32768.037fbef192
Root Bridge Id : 32768.01f47483e2
Root Path Cost : 25
Root Port Id : 0
Bridge Status : Enabled
Bridge Priority : 32768
Bridge Hello Time : 2 Seconds
Bridge Maximum Age : 20 Seconds
Bridge Forward Delay: 15 Seconds
============================= Port Summary =============================
Id| Priority | Path Cost | Fast Forward | Status | State |
0 128 25 Enable Enabled Forwarding
Outdoor Bridge#
Command Function Mode Page
filter ap-manage Prevents access to the management interface over the
wireless bridge link
GC 6-40
filter ethernet-type enable Checks the Ethernet type for all incoming and outgoing
Ethernet packets against the protocol filtering table
GC 6-41
filter ethernet-type
protocol
Sets a filter for a specific Ethernet type GC 6-41
show filter Shows the filter configuration Exec 6-42