User guide

WDS Commands
6-31
6
wds mac-address
This command enters wireless MAC addresses in the WDS forwarding table for
each node in the wireless bridge network.
Syntax
wds mac-address <port-id> <mac-address>
• port-id - The wireless port number for the bridge link. (1 for Slave units; 1-16
for Master units)
• mac-address - The wireless MAC address of the remote bridge unit for this
link. (12 hexadecimal digits in the form “xx-xx-xx-xx-xx-xx”)
Default
none
Command Mode
Global Configuration
Command Usage
• You can only configure one MAC address per wireless port ID.
• The wireless MAC address for each bridge unit is printed on the label on the
back of the unit.
Example
wds enable
This command enables WDS forwarding for a wireless port ID. Use the no form to
disable WDS forwarding for a wireless port ID.
Syntax
[no] wds enable <port-id>
• port-id - The wireless port number for the link. (1 for Slave units; 1-16 for
Master units)
Default
WDS forwarding disabled on all ports
Command Mode
Global Configuration
Example
Outdoor Bridge(config)#wds mac-address 1 00-12-34-56-78-9a
Outdoor Bridge(config)#
Outdoor Bridge(config)#wds enable 1
Outdoor Bridge(config)#