User guide

SNMP Commands
6-23
6
Example
SNMP Commands
Controls access to this wireless bridge from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
snmp-server community
This command defines the community access string for the Simple Network
Management Protocol. Use the no form to remove the specified community string.
Syntax
snmp-server community string [ro | rw]
no snmp-server community string
• string - Community string that acts like a password and permits access to
the SNMP protocol. (Maximum length: 23 characters, case sensitive)
• ro - Specifies read-only access. Authorized management stations are only
able to retrieve MIB objects.
• rw - Specifies read/write access. Authorized management stations are able
to both retrieve and modify MIB objects.
Outdoor Bridge#show sntp
SNTP Information
=========================================================
Service State : Enabled
SNTP (server 1) IP : 137.92.140.80
SNTP (server 2) IP : 192.43.244.18
Current Time : 08 : 04, Jun 20th, 2003
Time Zone : +8 (TAIPEI, BEIJING)
Daylight Saving : Enabled, from Jun, 1st to Sep, 1st
=========================================================
Outdoor Bridge#
Command Function Mode Page
snmp-server community Sets up the community access string to permit access to
SNMP commands
GC 6-23
snmp-server contact Sets the system contact string GC 6-24
snmp-server enable
server
Enables SNMP service and traps GC 6-25
snmp-server host Specifies the recipient of an SNMP notification operation GC 6-25
snmp-server location Sets the system location string GC 6-26
show snmp Displays the status of SNMP communications Exec 6-26