Installation manual

Command Manual - Port
Quidway S3000-EI Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-4
Field Description
Hardware address Port hardware address
Description Port description character string
The Maximum Transmit Unit Maximum transmit unit
Media type Type of media
loopback not set Port loopback test state
Port hardware type Port hardware type
100Mbps-speed mode, full-duplex
mode
Link speed type is autonegotiation,
link duplex type is autonegotiation
Both the duplex mode and the rate are set
to auto-negotiation. The rate of 100Mbps
and the mode of full-duplex are adopted
after negotiating with its peer
Flow-control is enabled Port flow control is enabled.
Value of flow-constrain Traffic threshold on the port
Process method when overflow the
constraint
Handling pattern when actual traffic on the
port exceeds the threshold
Period of flow-constrain detection Time interval to detect traffic on the port
The Maximum Frame Length
Maximum length of the Ethernet frames
that can pass through the port
Broadcast MAX-ratio Port broadcast storm suppression ratio
PVID Port default VLAN ID
Mdi type Cable type
Port link-type Port link type
Tagged VLAN ID The VLANs with packets tagged
Untagged VLAN ID The VLANs with packets untagged
Last 300 seconds input: 0
packets/sec 0 bytes/sec
Last 300 seconds output: 0
packets/sec 0 bytes/sec
The input/output rate and the passing
packet number on this port in the last 300
seconds