Installation manual

Command Manual - Remote Power-feeding
Quidway S3000-EI Series Ethernet Switches
Chapter 1 Remote Power-feeding Configuration
Commands
Huawei Technologies Proprietary
1-1
Chapter 1 Remote Power-feeding Configuration
Commands
1.1 Remote Power-feeding Configuration Commands
1.1.1 display poe interface
Syntax
display poe interface { interface-name | interface-type interface-num | all }
View
Any view
Parameter
interface-name | interface-type interface-num: Port of the switch, for detailed
description, please refer to Command Manual – Port.
all: view the remote power-feeding status of all ports.
Description
Using the display poe interface command, you can view the remote power-feeding
status of specified port or all ports.
Example
# Display the remote power-feeding status of Ethernet0/1.
<Quidway> display poe interface ethernet0/1
Port power enabled :enable
Port power ON/OFF :off
Port power status :pse normal
Port power mode :signal
Port PD class :0
port power priority :low
Port max power :10000 mW
Port power :0 mW
Port Average power :0 mw
Port Peak power :0 mw
Port current :0 mA
Port voltage :2 V