Installation manual

Command Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-12
7.1.15 ntp-service source-interface
Syntax
ntp-service source-interface { interface-name | interface-type interface-number }
undo ntp-service source-interface
View
System view
Parameter
interface-name: Specify an interface. The source IP address of the packets will be
taken from the address of the interface.
interface-type: Specify the interface type and determine an interface with the
interface-number parameter.
interface-number: Specify the interface number and determine an interface with the
interface-type parameter.
Description
Using ntp-service source-interface command, you can designate an interface to
transmit NTP message. Using undo ntp-service source-interface command, you can
cancel the current setting.
The source address specifies where the packets are transmitted from.
You can use this command to designate an interface to transmit all the NTP packets
and take the source address of these packets from its IP address. If you do not want
any other interface to receive the acknowledgement packets, use this command to
specify one interface to send all the NTP packets.
Example
# Configure all the outgoing NTP packets to use the IP address of Vlan-Interface1 as
their source IP address.
[Quidway] ntp-service source-interface Vlan-Interface 1
7.1.16 ntp-service in-interface disable
Syntax
ntp-service in-interface disable
undo ntp-service in-interface disable
View
VLAN interface view