Installation manual

Command Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-28
specified channels. You can configure the channels in the output direction, channel
filter information, filtering and redirecting of all kinds of information.
At present, the system distributes an information channel in each output direction by
default, shown as follows:
Table 4-1 The default name of information channel
Output direction Information channel name
Console console
Monitor monitor
Info-center loghost loghost
Log buffer logbuf
Trap buffer trapbuf
snmp snmpagent
In addition, each information channel has a default record with the module name “all”
and module number as 0xffff0000. However, for different information channel, the
default log, trap and debugging settings in the records may be different with one
another. Use default configuration record if a module does not have any specific
configuration record in the channel.
Example
# Configure to enable the log information of VLAN module in SNMP channel and allows
the output of the information with a level higher than emergencies.
[Quidway] info-center source vlan channel snmp log level emergencies
4.5.12 info-center switch-on
Syntax
info-center switch-on { unit-id | master | all } [ debugging | logging | trapping ]*
undo info-center switch-on { unit-id | master | all } [ debugging | logging |
trapping ]*
View
System view
Parameter
unit-id: Unit ID of switch.
master: master switch of Fabric.
all: all switches of Fabric.