Installation manual

Command Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-27
View
System view
Parameter
modu-name: Module name.
default: All the modules.
log: Log information.
trap: Trap information.
debugging: Debugging information.
level: Level.
severity: Information level, do not output information below this level.
Information at different levels is as follows:
emergencies: Level 0 information, which cannot be used by the system.
alerts: Level 1 information, to be reacted immediately.
critical: Level 2 information, critical information.
errors: Level 3 information, error information.
warnings: level 4 information, warning information.
notifications: Level 5 information, showed normally and important.
informational: Level 6 information, notice to be recorded.
debugging: Level 7 information, generated during the debugging progress.
channel-number: Channel number to be set.
channel-name: Channel name to be set. The name can be channel6, channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer.
state: Set the state of the information.
state: Specify the state as on or off.
Description
Using info-center source command, you can add/delete a record to the information
channel. Using undo info-center source command, you can cancel the contents of
the information channel.
For example, for the filter of IP module log output, you can configure to output the logs
at a level higher than warnings to the log host and output those higher than
informational to the log buffer. You can also configure to output the trap information on
the IP module to a specified trap host, etc.
The channels for filtering in all the directions are specified by this configuration
command. All the information will be sent to the corresponding directions through the