Installation manual

Command Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-24
[Quidway] user-interface 0 5
[Quidway-ui0-5]
1.1.32 user privilege level
Syntax
user privilege level level
undo user privilege level
View
User interface view
Parameter
level: Specifies which level of command a user can use after logon from the specifically
user interface, ranging from 0 to 3.
Description
Using user privilege level command, you can configure which level of command a
user can use after logon from the specifically user interface, so that a user can use all
the available commands at this level. Using undo user privilege level command, you
can restore the default level of command a user can use after logon from the
specifically user interface.
By default, a user can access the commands at Level 3 after logging in through the
AUX user interface, and the commands at Level 0 after logging in through the VTY user
interface.
Example
# Configure to use commands level 0 after logging in from VTY 0 user interface.
[Quidway-ui-vty0] user privilege level 0
# After you telnet from VTY 0 user interface to the switch, you will view the terminal only
displays commands at level 0.
<Quidway> ?
User view commands:
language-mode Specify the language environment
ping Ping function
quit Exit from current command view
super Privilege specified user priority level
telnet Establish one TELNET connection
tracert Trace route function