Installation manual

Command Manual - Network Protocol
Quidway S3000-EI Series Ethernet Switches
Chapter 5 Access Management Configuration
Commands
Huawei Technologies Proprietary
5-4
Example
# Display the access management configurations on Ethernet0/1 and Ethernet0/2.
<Quidway> display am ethernet0/1 ethernet0/2
Ethernet0/1
Status : disabled
IP Pools : (NULL)
Isolate Ports: Ethernet0/2
Ethernet0/2
Status : disabled
IP Pools : (NULL)
Isolate Ports: Ethernet0/1
Table 5-1 Description of information generated by the command display am
Field Description
Ethernet Port to be displayed
Status AM state on the port: enabled or disabled
IP Pools
IP pools. NULL represents no configuration. Each IP address
section is represented in X.X.X.X (number), of these, “X.X.X.X”
represents the first address, and “number” represents that
“number” consecutive IP addresses from the beginning of this
address are within the IP pools
Isolate Ports Isolate ports. NULL represents no configuration
5.1.5 display am user-bind
Syntax
display am user-bind [ interface { interface-name | interface-type interface-number } |
mac-addr mac | ip-addr ip ]
View
Any view
Parameter
interface-name: Specifies the port name in the interface-name= interface-type
interface-number format. interface-type: Specifies the port type. interface-number:
Specifies the port number. For parameter description, refer to the interface command.
mac: MAC address.
ip: IP address.