Installation manual

Command Manual - Network Protocol
Quidway S3000-EI Series Ethernet Switches
Chapter 5 Access Management Configuration
Commands
Huawei Technologies Proprietary
5-3
Parameter
interface-name: Specifies the port name in the interface-name= interface-type
interface-number format. interface-type: Specifies the port type. interface-number:
Specifies the port number. For parameter description, refer to the interface command.
mac: MAC address.
ip: IP address.
Description
Using am user-bind command, you can bind port, IP address and MAC address.
Using undo am user-bind command, you can remove the binding of port, IP address
and MAC address binding.
Note that:
z One MAC address or one IP address cannot be bound more than once.
z The maximum binding number is 128.
z Do not perform “Port+IP+MAC” and “Port+IP” on the same port.
Example
# Bind port Ethernet0/1 and IP address 192.10.1.1.
[Quidway] am user-bind interface ethenet0/1 ip-addr 192.10.1.1
5.1.4 display am
Syntax
display am [ interface-list ]
View
Any view
Parameter
interface-list: Specifies a list of ports isolated from the specified port in the
{ { interface-type interface-number | interface-name } [ to { interface-type
interface-number | interface-name } ] } &<1-10> format. interface-name: Specified the
port name, represented with interface-name= interface-type interface-number.
interface-type is port type and interface-number is port number. For details about
interface-type, interface-number and interface-name, refer to the Port Command
Manual. &<1-10> indicates the preceding parameter can be input up to 10 times.
Description
Using display am command, you can view the current access management
configurations on part or all of the ports.