Installation manual

Command Manual - Network Protocol
Quidway S3000-EI Series Ethernet Switches
Chapter 5 Access Management Configuration
Commands
Huawei Technologies Proprietary
5-1
Chapter 5 Access Management Configuration
Commands
5.1 Access Management Configuration Commands
5.1.1 am enable
Syntax
am enable
undo am enable
View
System view
Parameter
None
Description
Using am enable command, you can enable the access management function. Using
undo am enable command, you can disable the function.
By default, Access management function disabled.
When using the access management function, It is recommended to cancel the static
ARP configuration to ensure that the binding of IP address and Ethernet switch take
effect. If you have configured the static ARP for an IP address in the current port IP
address pool from some other port, the system will prompt to cancel the static ARP
setting.
Example
# Enable the access management function.
[Quidway] am enable
5.1.2 am isolate
Syntax
am isolate interface-list
undo am isolate interface-list