Installation manual

Command Manual - Network Protocol
Quidway S3000-EI Series Ethernet Switches Chapter 1 ARP Configuration Commands
Huawei Technologies Proprietary
1-3
aging-time: Aging time of dynamic ARP aging timer, which is in the range of 1 to 1440
minutes. By default, the aging time is 20 minutes.
Description
Using arp timer aging command, you can configure the dynamic ARP aging timer.
Using undo arp timer aging command, you can restore the default dynamic ARP
aging time.
For the related command, see display arp timer aging.
Example
# Configure the dynamic ARP aging timer to 10 minutes.
[Quidway] arp timer aging 10
1.1.4 debugging arp packet
Syntax
debugging arp packet
undo debugging arp packet
View
User view
Parameter
None
Description
Using debugging arp packet command, you can enable ARP debugging. Using undo
debugging arp packet command, you can disable the corresponding ARP debugging.
By default, undo ARP debugging is enabled.
For the related command, see arp static, display arp.
Example
# Enable ARP packet debugging.
<Quidway> debugging arp packet
*0.771346-ARP-8-S1-arp_send:Send an ARP Packet, operation : 1,
sender_eth_addr :
00e0-fc00-3500,sender_ip_addr : 10.110.91.159, target_eth_addr :
0000-0000-0000
, target_ip_addr : 10.110.91.193
*0.771584-ARP-8-S1-arp_rcv:Receive an ARP Packet, operation : 2,
sender_eth_addr