Installation manual

Command Manual - Security
Quidway S3000-EI Series Ethernet Switches Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-17
Parameter
interface interface-list: Ethernet interface list, represents multiple Ethernet interfaces,
in the format of interface-list = { interface-num [ to interface-num ] } & < 1-10 >.
interface-num is a single Ethernet port, in the format of interface-num = { interface-type
interface-num | interface-name }.
Description
Using the dot1x version-check command, you can enable the 802.1x client version
authentication feature on a specific port. Using the undo dot1x version-check
command, you can disable the feature on a specific port.
By default, 802.1x client version authentication feature is disabled on all ports.
In system view, if the interface-list parameter is not specified, it means that to enable
the 802.1x client version authentication feature on all interfaces; if the interface-list
parameter is specified, it means that to enable the feature on the specified interfaces. In
Ethernet port view, the interface-list parameter cannot be specified, and you can use
command only to enable the feature on the current interface.
Example
# Configure the port Ethernet 0/1 to detect the version of the 802.1x client when it
receives an authentication packet.
[Quidway-Ethernet0/1] dot1x version-check
1.1.17 reset dot1x statistics
Syntax
reset dot1x statistics [ interface interface-list ]
View
User view
Parameter
interface interface-list: Ethernet port list including several Ethernet ports. interface-list
= { interface-num [ to interface-num ] } & < 1-10 >. interface-num specifies a single
Ethernet port in the format port-num = { interface-type interface-num | interface-name },
where interface-type specifies the port type, interface-num specifies the port number
and interface-name specifies the port name. For the respective meanings and value
ranges, read the Parameter of the Port Configuration section.
Description
Using reset dot1x statistics command, you can reset the statistics of 802.1x.