Installation manual

Command Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 1 Logging in Switch Commands
Huawei Technologies Proprietary
1-16
View
Local-user view
Parameter
ftp: Specifies user type as ftp.
ftp-directory directory: Specifies the directory of ftp users, directory is a character
string of up to 64 characters.
lan-access: Specifies user type to lan-access, which mainly refers to Ethernet
accessing users, 802.1x supplicants for example.
ssh: Specifies user type as SSH.
telnet: Specifies user type as Telnet.
level level: Specifies the level of Telnet or SSH users. The argument level is an integer
in the range of 0 to 3 and defaults to 1.
Description
Using service-type command, you can configure which level of command a user can
use after logon. Using undo service-type command, you can restore the default level
of command a user can use after logon.
Commands are classified into four levels, namely visit level, monitoring level, system
level and management level. They are introduced as follows:
z Visit level: Commands of this level involve command of network diagnosis tool
(such as ping and tracert), command of switch between different language
environments of user interface (language-mode), and telnet command etc. The
operation of saving configuration file is not allowed on this level of commands.
z Monitoring level: Commands of this level, including the display command and the
debugging command, are used for system maintenance, service fault diagnosis,
etc. The operation of saving the configuration file is not allowed on this level of
commands.
z System level: Service configuration commands, including routing command and
commands on each network layer, are used to provide direct network service to
the user.
z Management level: These are commands that influence the basic operation of the
system and system support module, which plays a supporting role on service.
Commands of this level involve file system commands, FTP commands, TFTP
commands, XModem downloading commands, user management commands,
and level setting commands.
Example
# Configure the user zbr to use commands at level 0 after logon.
[Quidway] local-user zbr