Installation manual

Command Manual - Security
Quidway S3000-EI Series Ethernet Switches Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 802.1x Configuration Commands
1.1 802.1x Configuration Commands
1.1.1 display dot1x
Syntax
display dot1x [ sessions | statistics ] [ interface interface-list ]
View
Any view
Parameter
sessions: Configures to display the session connection information of 802.1x.
statistics: Configures to display the relevant statistics information of 802.1x.
interface: Configures to display the 802.1x information on the specified interface.
interface-list: Ethernet interface list including several Ethernet interfaces, expressed in
the format interface-list = { interface-num [ to interface-num ] } & < 1-10 >.
interface-num specifies a single Ethernet interface in the format interface-num =
{ interface-type interface-num | interface-name }, where interface-type specifies the
interface type, interface-num specifies the interface number and interface-name
specifies the interface name. For the respective meanings and value ranges, read the
Parameter of the Port Command Manual section.
Description
Using display dot1x command, you can view the relevant information of 802.1x,
including configuration information, running state (session connection information) and
relevant statistics information.
If no port is specified when executing this command, the system will display all 802.1x
related information. The output information of this command can help the user to verify
the current 802.1x configurations so as to troubleshoot 802.1x .
For the related commands, see reset dot1x statistics, dot1x, dot1x retry, dot1x
max-user, dot1x port-control, dot1x port-method, dot1x timer.
Example
# Display the configuration information of 802.1x.
<Quidway> display dot1x
Equipment 802.1X protocol is enabled